Keys fitness health trainer 85t treadmill owner's manual 29 pages. Keys fitness healthtrainer treadmill owner's manual 35 pages. Page 6 Notes To determine what model of treadmill you are servicing, look at the sticker on the front of the treadmill frame next to the reset button. Page 8: Trouble Shooting C. Remove the Safety Key from the console and re-attach to console. Recalibrate treadmill. The walking belt slows during use.
Page 9 A. Adjust rear roller. The walking belt slips or hesitates during use. Knocking noise from the front of treadmill. Check fan 1. Is fan hitting optical encoder? Is fan hitting flywheel?
To avoid possible damage to the treadmill it should not be operated until the problem is corrected. If re- calibrate does not work replace console.
Page 11 D. Check to see if wiring harness wires are pinched or frayed. If re-calibration does not work treadmill has a bad motor controller of DC motor drive. E 33 The walking belt is moving at a faster speed than displayed in the speed window A. Page 12 F. Check fuses on motor controller. Indicates that power up sequence was initiated with the treadmill in the upright folded position.
Fold down the treadmill to normal operating position treadmill should be folded down to the floor , try again. If this LED is lit but the motor is not moving, check connections to the motor at the controller and at the motor. To check operation, with the treadmill plugged in but not powered up, slowly rotate the motor by hand by pushing the flywheel. Safety Key. Remove console cover and verify reed switch if equipped harness is connected If unit has no reed switch, Replace Console Unit is Fixed until it stops and re-calibrate E33 Code?
Board Replace Motor RLY1 will be on at power up Power down unit- and stay on for a 10 second Page 35 3. Re- covers align if necessary. Page Schematic Diagrams Schematic Diagrams Replace Safety Key. Treadmill will turn off on its own. After electrical re-installation of motor actuator, motor controller or electronics, re-calibration is necessary. Calibration- LCD Display Treadmill will turn off on its own After electrical re-installation of motor actuator, motor controller or electronics, re-calibration is necessary.
Do not unplug treadmill. Attach the magnet safety key to the console. Apply the silicone spray to the walking board, moving from the front of the treadmill to the rear. Repeat this on the other side of the belt. Spray approximately 4 seconds on each side. Unfold treadmill into flat position. See Figure 5 for location of mounting bolts on the front side of the unit.
Make sure all wires are disconnected from motor controller and treadmill frame. Remove motor from bracket assembly. Use hammer to tap bolts carefully out of bracket assembly. See Figure 6. Page 55 7.
Verify position of bolts to be moved as shown in Figure 7. Push down on inside corner of base pan to remove bolts from current hole position. See Figure 8. Page 56 Use a hammer to push forward toward front of unit to tighten the Poly V Belt.
At the same time, tighten all 4 four mounting bolts as shown in Figure Re-connect all power wires to motor controller and install ground wire to frame as shown in Figure Return from Keys Treadmill to Keys Treadmills. Check and compare Treadmills here before you buy any. Check my pricing, ongoing promotions, manufacturer, mark and model , etc then make a decision.
Help other people avoid costly mistakes by encouraging or dissuading them to buy a treadmill similar to yours. Visit our best treadmill or worst treadmill experience page. All images, brands and trademarks are property of their respective owners. Never Miss Any Updates or News! I promise to use it only to send you Treadmill Addicts Newsletter. Featured Treadmills. Follow us. All rights reserved.
0コメント